Old Bathroom Light Has Several Wires From Wall

Coming out of the ceiling there are 2 cables and in each are a red black and yellow green cables 6 in total and the light that i have bought to go up there has access for a blue and a brown wire.

Old bathroom light has several wires from wall.

Split off the small pieces of lath behind. Cutting the hole accurately is critical so that the box ears have solid bearing on the plaster photo 4. If you are at the junction box that is in the wall where the old light fixture was then there should be only 2 wires that the old fixture was fastened to. Push the old house wiring through these clamps and work them farther in as you insert the box into the wall.

Twist all of the black wires from the light bar together with the black wire from the wall switch and connect the ends using a wire nut. There may also be small screws on the sides of the light holding it to the mounting plate. If all is safe remove one wire nut at a time separate the wires and screw the wire nut back on the wall side. Then connect all of the white wires together with a wire.

7 connect the wiring from the new light fixture to the wires leading from. I bought a light for my son s bedroom but when i detached the old light i found to my horror 6 wires rather than the expected 2. Remodeling boxes have internal clamps for the wires. Remove any screws holding the light base to the wall.

Strip 1 2 inch of insulation from the black white and green wires on the new light fixture with a pair of wire strippers. The moving parts of a standard light switch are enclosed inside plastic casing so when the switch goes bad your only option is to replace it. Connect the lead wires from the fixture to the black hot wire in the electrical box by twisting a wire connector to the ends of the lead and hot wires. How to troubleshoot a faulty wall switch.

Once the light is separated from the base check all wires for voltage. Light fixtures with more than one lamp may have a pair of black and white wires for each lamp.